Vertical hanging tilt switch probe PLR30 Vertical hanging tilt switch probe PLR30 Vertical hanging tilt switch probe PLR30 Features: The tilt switch can be used alone with the probe or in conjunction with the control device. The alarm output time is adjustable, and the control device has an adjustable delay line of 0-10 seconds, which can avoid false action of the tilt switch caused by instantaneous tilt. The normal/alarm position can be set, and there is a jumper in the control device that can set the switch to a normal or tilted state. It is sturdy, corrosion-resistant, and easy to install. The control device is a printed circuit board structure, and all probes are equipped with installation accessories& nbsp; Technical specifications Power supply: 220 VAC± 10%, 47-62 Hz, 10W output: One DPDT contact with rated capacity of 5Amp/220 VAC or 5 Amp/28VDC, non inductive load time delay: 0-10 seconds, adjustable jumper: allows the switch to be set to normal state in vertical or tilted state. Tilt switch probe
& nbsp;      When the tilt switch probe of the vertical suspension is subjected to external force and deviates from the vertical position by more than 15 degrees, the metal ball contact inside the switch will act, and the normally closed contact will open. After the external force is removed, the tilt switch returns to the vertical state, and the metal ball contacts close again. Using the changes in the opening and closing of the internal contacts of the tilt switch to determine the working condition of the equipment, in order to take timely measures and achieve the purpose of safety protection& nbsp;LJ18A3-5（8）-Z/AX & nbsp; LJ18A3-5（8）-Z/BY & nbsp; LJ18A3-5（8）-Z/BX & nbsp;LJ2A3-2（4）-Z/CYLJ12A3-2（4）-Z/CX & nbsp;LJ12A3-2（4）-J/DZ & LJ12A3-2 (4) - J/EZ proximity switch& nbsp;LJ12A3-2（4）-Z/DX & nbsp;LJ12A3-2（4）-Z/EX & nbsp;LJ12A3-2（4）-Z/AY & nbsp; LJ12A3-2（4）-Z/AX & nbsp;LJ12A3-2（4）-Z/BX